Online-Handbücher
Blatzheim.com | Startseite | Firmware | Anmelden
Suchen:
Handbücher  >>  BM-33k6/ISDN pro  >>  Troubleshooting  >>  Prüfen: ISDN Fehlermeldungen

Prüfen: ISDN Fehlermeldungen

Falls bei der Wahl ständig ein NO CARRIER kommt, kann das Modem in den meisten Fällen einen Grund dafür nennen. Durch den Befehl AT$V15CR wird das Modem gesprächig und gibt den vom ISDN-Netz übermittelten Grund nach dem NO CARRIER im Klartext aus.

In den meisten Fällen wird die Nummer nicht richtig sein.

  • Ungewollte analoge Wahlmodifier wie W,<,>,T,P
  • Zu wenig oder zu viele Nullen im Wahlstring
  • B-Kanäle auf dem S0-Bus schon belegt

Liste der ISDN-Meldungen:

1Unallocated number
2No route to specified transit network
3No route to destination
6Channel unacceptable
7Call awarded and being delivered in an established channel
16Normal call clearing
17User busy
18No user responding
19No answer from user (user alerted)
21Call rejected
22Number changed
26Non-selected user clearing
27Destination out of order
28Invalid number format
29Facility rejected
30Response to STATUS REQUIRY
31Normal, unspecified
34No circuit/channel available
38Network out of order
41Temporary failure
42Switching equipment congestion
43Access information discarded
44Requested circuit/channel not available
47Resources unavailable, unspecified
49Quality of service unavailable
50Requested facility not subscribed
57Bearer capability not authorized
58Bearer capability not presently available
63Service or option not available, unspecified
65Bearer capability not implemented
66Channel type not implemented
69Requested facility not implemented
70Only restricted digital information bearer capability is available
79Service or option not implemented, unspecified
81Invalid call reference value
82Identified channel does not exist
83A suspended call exists, but this call identity does not
84Call identity in use 85: No call suspended
86Call having the requested call identity has been cleared
88Incompatible destination
91Invalid transit network selection
95Invalid message, unspecified
96Mandatory information element is missing
97Message type non-existent or not implemented
98Message not compatible with call state
99Information element non-existent or not implemented
100Invalid information element contents
101Message not compatible with call state
102Recovery on timer expiry
111Protocol error, unspecified
127Interworking, unspecified

 
Gültig für jede Firmware

 
Copyright © 2003-2009 ? bn:t Blatzheim Networks Telecom GmbH
All rights reserved.
Best viewed with: Internet Explorer ? 5.0, Netscape ? 6.0, Mozilla ? 1.0, Opera ? 6.0
Änderungen und Irrtümer vorbehalten
 
Letzte Änderung am 09.10.2009 um 10:48 Uhr